Installation instructions, Fitting and removal of baffle – Stovax REGENCY 1000 User Manual
Page 19

19
PR7219R
Self tappping
screw at rear
Flue Pipe 915mm (3ft)
Size
Stovax Part No.
*5"
4502
6"
4602
Seal flue collar
with Fire Cement
Flue Adapter
Size
Stovax Part No.
8"
4819
INsTAllATIoN INsTRUCTIoNs
PR7220R
600mm min
1000mm max
unsupported
Elbow with access cover
Size
Stovax Part No.
8"
4812
Flue Pipe 915mm (3ft)
Size
Stovax Part No.
8"
4810
To chimney connection
as detailed in building
regulations
Flue Adapter
Size
Stovax Part No.
8"
4819
1.3 Rear flue pipe installation
• Insert a tee into the flue collar
The tee piece is used as cleaning access.
• Lift appliance into position
Take care not to damage the hearth finish.
• Level using adjustable bolts, see picture 1
• Connect tee to the chimney using flue pipe
• Secure with self tapping screw
• Seal the connecting joints
Do not use a 90˚ elbow to make this connection
The Flue must be installed in accordance with
manufacturers instructions.
Flue Adapter
Size
Stovax Part No.
8"
4819
PR7218R
Seal collar with fire cement
Self tapping screw
Tee
Size
Stovax Part No.
8"
4817
Cap
PR7221R
600mm min
1000mm max
unsupported
Elbow with access cover
Size
Stovax Part No.
8"
4812
Flue Pipe 915mm (3ft)
Size
Stovax Part No.
8"
4802
Flue Adapter
Size
Stovax Part No.
8"
4819
2. FITTING ANd ReMoVAl oF BAFFle
2.1 To maintain safe and efficient combustion the appliance is
fitted with a baffle in the top of the firebox.
2.2 Allow the appliance to cool fully before removing baffle
system.
2.3 To remove the baffle, lift the baffle plate, rotate it and then
slide it out through the front.
2.4 It is important to remove and clean the baffle system to
ensure the flue ways are clear of soot and debris and to
ensure the safe and efficient operation of the appliance.
The frequency of cleaning will depend on the appliance
operating conditions.
2.5 Replace any damaged baffles immediately.
2.6 Do not modify the baffle system.
2.7 To remove the baffle, lift the baffle plate, rotate it and then
slide it out through the front.
2.8 Replacement is the reverse of the above.