Grizzly Planishing Hammer G0497 - Manual (Page 2)

Figure 4. Planishing hammer and anvil.
Hammer
Anvil
Maintenance
Before Every Use
•
Check oil level in the lubricator; refill as need-
ed with an SAE 10-weight non-detergent,
non-additive oil.
• Check all mounting and component hardware
and fasteners; adjust/tighten as necessary.
• Check all air connections; replace leaking or
defective connections.
• Check for worn or shorted wiring; replace as
necessary.
If you need help with your new planishing ham-
mer, call our Tech Support at: (570) 546-9663.
5. Plug the planishing hammer into the power
supply.
6. With the workpiece between the hammer and
anvil ( Figure 4), depress the foot pedal to
begin planishing.
2. Set the desired air pressure between 90-120
PSI using the filter/regulator dial. A lower air
pressure will provide a softer hammer blow.
3. Adjust the oil flow using the dial at the top of
the lubricator. A setting of 2 drips per minute
is sufficient for regular operation.
4. Adjust the anvil height with the handwheel,
and lock the anvil in position by snugging the
lock handle against the hammer frame, as
shown in
Figure 3.
������
���������
������
�������
��������
����
�����������
����������
������
����������
����������������
Figure 2. Correct air supply setup.
Operation
1. Connect the planishing hammer to the air
supply as shown in Figure 2.
Figure 3. Lock handle and handwheel.
Lock Handle
Handwheel