Goodman Mfg SS-DSZC18 - Manual (Page 3)

2 www.goodmanmfg.com SS-DSZC18 SS-DSZC18 www.goodmanmfg.com 3
P
roduct
S
PecificationS
P
roduct
S
PecificationS
S
peCifiCationS
DSZC18
0361A
DSZC18
0481A
DSZC18
0601B
Cooling Capacity
Nominal Cooling (BTU/h)
35,000 47,000 57,000
Nominal Heating (BTU/h) 35,000 47,000 57,000
Decibels 72 73 75
Compressor
RLA
15.3 21.2 28.8
LRA 83 104 152.9
Condenser Fan Motor
Horsepower (RPM)
⅓ ⅓ ⅓
FLA 2.8 2.8 2.8
Refrigeration System
Refrigerant Line Size¹
Liquid Line Size (“O.D.) ⅜" ⅜" ⅜"
Suction Line Size (“O.D.) ⅞" 1⅛" 1⅛"
Refrigerant Connection Size
Liquid Valve Size (“O.D.) ⅜" ⅜" ⅜"
Suction Valve Size (“O.D.) ⅞" 1⅛" 1⅛"
Valve Connection Type Sweat Sweat Sweat
Refrigerant Charge 188 278 278
Expansion Device TXV TXV TXV
Superheat at Service Valve 7-9°F 7-9°F 7-9°F
Subcooling at Service Valve
High Stage
8-10°F 8-10°F 8-10°F
Low Stage 5-7°F 5-7°F 5-7°F
Electrical Data
Voltage-Phase-Hz
208/230-1-60 208/230-1-60 208/230-1-60
Minimum Circuit Ampacity ² 21.9 29.3 38.8
Max. Overcurrent Protection ³ 35 50 60
Min / Max Volts 197 / 253 197 / 253 197 / 253
Electrical Conduit Size ½" or ¾" ½" or ¾" ½" or ¾"
Equipment Weight (lbs) 250 305 316
Ship Weight (lbs) 272 327 338
¹ Tested and rated in accordance with AHRI Standard 210/240
² Wire size should be determined in accordance with National Electri-
cal Codes; extensive wire runs will require larger wire sizes
³ Must use time-delay fuses or HACR-type circuit breakers of the same size as noted.
Notes
• Always check the rating plate for electrical data on the unit being installed.
• Installer will need to supply ⅞” to 1⅛” adapters for suction line connections.
• Unit is charged with refrigerant for 15’ of ⅜” liquid line. System charge must be ad-
justed per Installation Instructions Final Charge Procedure.
• Installation of these units requires the specified TXV Kit to be installed on the indoor coil. THE
SPECIFIED TXV IS DETERMINED BY THE OUTDOOR UNIT, NOT THE INDOOR COIL.