GE Monogram AEE18 - Manual (Page 10)

PREPARE THE CASE
Install the top mounting rail with 4 type B
screws from the inside of the case.
Press firmly to drive the screws into the
gasket and through the top mounting rail.
Insert the frames for the accordion panels
into the top mounting rail and the bottom
frame guides. Attach the accordion panels
to the side of the case using 3 type A screws
on each side.
NOTE: When attaching the accordion panels,
make sure to only screw the inner panels
to the case sides.
B
A
5
Window Installation Instructions
Top mounting rail
10
Type A
screws
Top mounting rail
Bottom mounting rail
BACK
PREPARE THE WINDOW
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
4
REMOVE THE AIR CONDITIONER
FROM THE CASE
(cont.)
Remove the locking screw and locking
bracket from the lower frame. Save to
reinstall later.
Remove the ground screw and save to
reinstall later.
Slide the air conditioner from the case by
gripping the base pan handle and pulling
forward while bracing the case.
G
F
E
Remove the ground screw
and save to reinstall later
3