Grizzly G6043 - Manual (Page 9)

Always disconnect air from stapler
whenever clearing a jammed staple!
G6042/G6043 18 Gauge Stapler Kit -8 -
Clearing Jammed Staples
The most frequent situation with any type
of stapler is a staple jam. A jammed staple
must be cleared before using the stapler
again. The two places where a staple can
get jammed are the magazine and the dis-
charge area.
To clear a jammed staple from the dis-
charge area:
1. Disconnect the stapler from the air
supply!
2. Remove all of the staples from the
magazine.
3. The jammed staple should now be
visible; remove it from the discharge
area with needle nose pliers.
4. Replace the staples. Push the maga-
zine closed and snap the quick
release latch back into operating posi-
tion.
To clear a jammed staple from the maga-
zine:
1. Disconnect the stapler from the air
supply!
2 . Open the magazine cover and pull the
magazine all the way back.
3. Locate and remove the jammed sta-
ple with a pair of needle nose pliers.
Close the magazine cover so it latch-
es.