GE Monogram ZIF360NXRH - Manual (Page 2)

For answers to your Monogram, ® GE Profile ™
or GE ® appliance questions, visit our website
at ge.com or call GE Answer Center ® service,
800.626.2000.
110153 Specification Created 6/08
ZIF360NX
GE Monogram ® 36" Built-In Custom All-Freezer
Dimensions and Installation Information
Listed by
Underwriters
Laboratories
Cutout and Clearances for Multiple Product Installations
For a complete food storage center, install a Monogram
All-Refrigerator and All Freezer side-by-side. For even
more capacity, install two refrigerators or two freezers.
If you are installing two units, side by side, the installation
space must be 71-1/2" wide. Additional cutout width may be
required when side panels are used. Add side panel thickness
to the finished cutout to calculate rough-in width.
• The water and electrical locations for each product must be
located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply is
recommended for each product.
251Dia35
251Dia61
25"
Min. to
Wall
0"
25"
Min. to
Wall
130ϒ Door Swing 130ϒ Door Swing
Clearances for two products installed side-by-side with
right and left side hinges together
Allow 5" minimum between the two products to prevent
one door from striking the other. Use the WX14X99
adjustable door stop to reduce the factory set 130˚ door
swing and to allow pan removal.
NOTE: A unified grille
panel kit will NOT fit this installation.
Clearances for Multiple Single Door Installations
In a side-by-side installation of a left and right door swing
product, the inside trims touch at the front, with a 1" clearance
between the units at the rear. Order ZUG2 Unified Grille Panel
Kit for one continuous grille panel using a 1/4" framed or 3/4"
overlay custom panel.
5"