Grizzly G1029Z - Manual (Page 16)

-14-
g1028z/g1029z dust Collector
assembly
To assemble your machine:
1. position the base plate upside down and
mount the casters to the base plate using
(16)
5 ⁄
16
"-18 x 1 ⁄
2
" flange bolts, as shown in
figure 4.
figure 4. mounting casters to base.
2. set the collector body on top of the base
plate so the intake portion is near the edge of
the base plate and the bolt holes are aligned,
as shown in
figure 5. secure the collector
body to the base plate with (4) 5 ⁄
16
"-18 x 1 ⁄
2
"
flange bolts.
figure 5. mounting collector to base.
3. insert the rubber gasket between the collec-
tor and lower outlet flange, and secure using
(8)
5 ⁄
16
"-18 x 1 ⁄
2
" flange bolts, as shown in
figure 6.
Note: When connecting parts that have a gas-
ket applied to the mounting surface, always
tighten the fasteners in a diagonal and rota-
tional manner to ensure the gasket does not
become crimped and the seal compromised.
figure 6. mounting outlet to collector body.
4. attach the lower collector support brackets
to the top edge of the base plate using (4)
5 ⁄
16
"-18 x 1 ⁄
2
" flange bolts, as shown in figure
7.
Collector Body
Flange Bolts
lower outlet Flange
figure 7. mounting support bracket to base.
lower
support
Brackets