GE 23-11-2129N-002 - Manual (Page 11)

Customer Service
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Assemble and Attach the Sill and Support Brackets
Loosely attach the sill brackets to the support
brackets with 5/8 ″ long carriage bolts and nuts.
Find the track hole that aligns with the sill
bracket on the outer edge of the window sill.
Using the 5/8 ″ long machine screws and nuts
attach the support brackets to the case track
hole on each side.
Attach both sill brackets to the window sill
using a 1 ″ long screw on each side.
Tighten the bolts and nuts on both sides.
NOTE: When finished, use a level to make
sure the case tilts to the outside 1/4
″
minimum.
This prevents water from entering the room.
D
C
B
A
6
Install the Case in the Window
Open the window and mark the centerline
on the stool.
Carefully place the case in the window and
align the center of the bottom tie bar with the
centerline on the window stool. Do not release
your grip on the case until the window is in its
final position.
Close the window until it touches behind the
top retainer bar.
Secure the case through the case track into the
window stool on each side, using two 1 ″ screws.
D
C
B
A
5
11
Mark centerline
Top retainer bar
Bottom tie bar
Secure to stool
Sill bracket
Track hole
Sill
Nut
Support bracket
Carriage bolt
Level