Grizzly G1182HW User Manual
Page 24
-22-
G1182 6" Series Jointers
3.
If there is a gap between the bevel’s blade
and the face of the fence, turn the stop bolt
until the gap is gone.
4.
Tighten jam nut. Move your fence forward,
then back against the stop. Recheck the stop
bolt.
Figure 23.
Jointer fence in 45° stop position.
Jointer knives are dangerously sharp. Use
extreme caution when handling knives or
working near them. Serious personal injury
may occur.
See also other documents in the category Grizzly Tools:
- H7670 (20 pages)
- H7792 (20 pages)
- H7947 (24 pages)
- G7958 (16 pages)
- G1007 (52 pages)
- G9861 (56 pages)
- G9861 (56 pages)
- Extreme Series Jointer G9860 (76 pages)
- H6331 (20 pages)
- G4179 (32 pages)
- G0500 (71 pages)
- T10446 (16 pages)
- G0463 (40 pages)
- H6143 (20 pages)
- G8125 (2 pages)
- H0800 (6 pages)
- POWER FEED H8370 (4 pages)
- H8116 (20 pages)
- G4003 (55 pages)
- G7948 (2 pages)
- T10010 (28 pages)
- H7668 (24 pages)
- Extren Series Jointer g9860 (76 pages)
- Panther 5 Shelf Unit T10001 (2 pages)
- 28 clipped head framing nailer h6145 (20 pages)
- G1021Z (39 pages)
- H7949 (32 pages)
- Extreme Duty Planners G9740 (76 pages)
- G4008 (26 pages)
- H8154 (1 page)
- 3/8" Impact Wrench w/ Front Exhaust H8119 (2 pages)
- Model H8222 (16 pages)
- G9953ZXF (76 pages)
- COMBINATION SANDER G1183 (48 pages)
- H7758/H7759 (28 pages)
- Extreme-Duty s G9740 (76 pages)
- G2790 (23 pages)
- G0633/G0634 (72 pages)
- G1006 (23 pages)
- Flex Shaft G9928 (12 pages)
- G0456 (48 pages)
- H8170/H8171 (32 pages)
- H7943/H7944 (24 pages)
- H0777 (10 pages)
- 5 GALLON AUTOMATIC MIXING PAINT TANK H8226 (16 pages)