Grizzly H7673 - Manual (Page 9)

Model H7673 HVLP Spray Gun -9 -
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Air Flow Control: Controls the fluid
pressure inside the spray gun.
4. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
5. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
6. Cup: 100 ml plastic cup allows easy
viewing of material level. Includes a
vented cap.
Figure 2. Installing filter.
Figure 3. Controls.
2. Screw the cup onto the top of the
body.
3. Install the barbed hose fitting into the
base of the gun handle and tighten in
place with the lock nut.
4. Secure the air hose to the barbed fit-
ting with a hose clamp.
Note: Using a 1 ⁄
4
" NPS quick discon-
nect set-up (not included), will make
operation and maintenance tasks
easier.
5. Attach the spray gun to an air hose
regulated between 43.5 and 58 PSI.
Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other pos-
sible contaminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
Controls Assembly
1. Insert the filter into the gun body (see
Figure 2).
Cup
Fluid Control
Pattern Control
Air Flow Control
Atomizing Cap
Trigger