Grizzly G9985 - Manual (Page 20)

-18- G9984/G9985 Oscillating Belt Edge Sander
The side table can be adjusted to accommodate
sanding at various angles. To adjust the angle
position of the side table:
1. Loosen the lock handle underneath the side
table shown in
Figure 19 .
2. Move the side table to the desired position.
3. While holding the side table in the desired
position, tighten the lock handle loosened in
Step 1 .
Side Table Angle
Figure 19. Lock handle for side table angle.
The side table can be adjusted to accommodate a
wide range of workpieces. To adjust the side
table:
1. Loosen the lock handle shown in Figure 18 .
2. Move the side table to the desired height.
3. While holding the side table at the desired
height, tighten the lock handle loosened in
Step 1 .
Side Table Height
Figure 18. Lock handle for side table height.
Figure 17. Setting miter gauge to 90°.
Lock Handle
Lock Handle