GE Monogram ZICS360N LH - Manual (Page 14)

Installation Instructions
14
STEP 9 INSTALL FRAMED PANELS
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR screw
holes.
• Follow the same procedures to install the drawer panel.
Custom handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door/drawer trim using both the FRONT
and REAR screw holes. Discard supplied handle.
Use Rear Holes
to Secure Handle
Use Front Holes
to Secure Trim
Right hand models shown. Use the same instructions for
left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS, GO
TO STEP 9A.
Install door and drawer panels:
• Open door to 90
°
. Remove the 4 Phillips head screws
from the door handle.
• Remove handle. Retain all screws.
• Remove 4 screws holding trim, lift off trim. Retain
screws.
• Slide framed panel into the door trim.
Standard supplied handle shown
in 1/4" panel position.
Refrigerator
Door
Door Trim Handle
Trim