Garmin STYLUS NX200 - Manual (Page 35)

Replacing Ink Cartridges 35
11. Close the scanner.
12. Press the y Stop button to begin charging the ink. This takes about
2½ minutes. When it’s finished, the P On light stops flashing and remains
on, and the B ink light goes out.
Caution:
Never turn off the NX200 Series while ink is charging or you’ll waste ink. If the
B ink light flashes, press the y Stop button and press down all the cartridges
securely.
Note:
If you replaced a cartridge while copying a document or photo, cancel printing and
make sure your original is still placed correctly on the document table. Then copy
your original again.
If you remove a low or expended ink cartridge, you cannot reinstall and use it.