Grizzly Portable Clamping Workbench G8586 - Manual (Page 2)

-2-
G8586 Portable Clamping Workbench
4.. install the other table bracket on the opposite
end of the table top in a similar manner.
5. Repeat Steps 2-4 to secure the table brack-
ets to the bottom of the rear table top.
6.. Place the table assembly onto the leg braces,
align the mounting holes, then secure with (4)
M8-1.25 x 45 hex bolts, hex nuts, and (8) flat
washers, as shown in
Figure 4.
Figure 4. Legs fastened to table assembly.
Foot
Clamping
Dog
7.. install the rubber feet on the legs (Figure 4)
so the longest side of each foot is at the cor-
ner.
8.. install the clamping dogs (Figure 4) in the
holes on the table tops, as required, to hold
your workpiece.
Operation
Turn the hand cranks to adjust the table tops
for clamping workpieces between the tables or
between the clamping dogs using the V-shaped
recesses.
G8586 Parts Breakdown
&
'
(
("&
("'
("(
)
*
+
,
-
.
&%
&& &'
&(
&+
&,
&-
&&
DO NOT use the Model G8586 as a step-
ladder.. Doing so could cause serious
personal injury..
NOTICE
Never exceed the listed capacity of the
workbench; doing this could break it..
REF PART # DESCRIPTION
1 P8586001 TABLE TOP (REAR)
2 PHTEK20M TAP SCREW M5 X 14
3 P8586003 TABLE BRACKET
3-1 P8586003-1 THREADED ROD
3-2 P8586003-2 THREADED SOCKET
3-3 P8586003-3 TABLE BRACKET HANDLE
4 PS81M PHLP HD SCR M6-1 X 40
5 PW03M FLAT WASHER 6MM
6 PN01M HEX NUT M6-1
7 P8586007 CROSSBAR (FRONT)
8 P8586008 LEG FRAME (R)
9 P8586009 RUBBER FOOT
10 PB15M HEX BOLT M8-1.25 X 40
11 PW01M FLAT WASHER 8MM
12 PLN04M LOCK NUT M8-1.25
13 P8586013 CLAMPING DOG
16 P8586016 TABLE TOP (FRONT)
17 P8586017 CROSSBAR (REAR)
18 P8586018 LEG FRAME (L)
x 2
x 2