Graco 8H98 - Manual (Page 18)

18
I. Attach the lap belt to the two rear-facing seat belt hooks locate at the
front bottom of the safety seat.
II. Pull the diagonal belt to suitable length to get around the back of the
seat, and then attach the diagonal belt to the rear-facing seat belt hooks
that locate at the back top of the seat.
Fig. 16.1 Diagonal belt
Fig. 16.2 Lap belt
• Attaching the seat belt to the hooks (Fig.17) .
5 Push the car seat down and against the vehicle seat. At the same time, pull
the seat belts to the direction so that the car seat is tightly and securely fit-
ted
(Fig.18) .
6 Recheck if the car seat is securely fitted after completing the above instal-
lations. (Check by moving the car seat back and forth)
Make sure that both the lap belt and diagonal belt are not twisted or fold-
ed, and will not prevent the vehicle seat belt to be fully and rightly func-
tioned
(Fig. 19) .
Installation to the Vehicle
(Forward Facing Mode,for child between 9~18kg)
Note that this mode must ONLY be used for child weighing between
9-18 kg (approximately between 1-4 years old)
lt is highly recommended to have the car seat installed at the back seats of
your vehicle.
(Fig. 20)
1 Pull the vehicle seat belt to suitable length then follow the following steps
to secure the safety seat.
I. Pull the vehicle seat belt through one front belt cover (Fig. 21)
II. Open the seat pad cover and pull the vehicle seat belt through (Fig. 22) .
III. Pass through the vehicle seat belt to the other front belt cover
(Fig. 23) .
IV. Secure the vehicle seat belt until a “CLICK“ sound is heard (Fig. 24) .
2 Push the car seat down against the vehicle seat. At the same time, pull the
seat belt to the direction as the figure shown so that the car seat is tightly
and securely fitted
(Fig. 25) – Push down .