GE JGB910 User Manual
Page 55
Customer Service
Installation Instructions
Troubleshooting T
ips
Operating Instructions
Safety Instructions
55
Problem
Possible Causes
What To Do
Display goes blank
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the
• See the Special features of your oven control section.
black-out mode.
Display flashes
Power failure.
• Reset the clock.
Unable to get the
Oven control pads were
• The BAKE and BROIL HI/LO pads must be touched at
display to show “SF”
not pressed properly.
the same time and held for 3 seconds.
Power outage,
Power outage or surge.
• Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a new oven
• To speed the process, set a self-clean cycle
odor emitting from
and will disappear in time.
for a minimum of 3 hours. See the Using the
the vent
self-cleaning oven section.
Strong odor
An odor from the insulation
• This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
The convection fan may turn on •
This is normal. The convection fan will run until the
and off automatically.
function is over or the door is opened.
Convection fan
Preheat temperature
• Fan will start automatically once the preheat
not working
not reached.
temperature is reached.
Drawer does not slide
The drawer is out of alignment.
• Fully extend the drawer and push it all the way in.
smoothly or drags
See the Care and cleaning of the range section.
Drawer is over-loaded or load
• Reduce weight. Redistribute drawer contents.
is unbalanced.
Warming zone or
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
warming drawer
blown or the circuit breaker
will not work
tripped.
The oven is self-cleaning.
• Wait for the self-clean cycle to finish and the oven
to cool.
Controls improperly set.
• See the Using the electric glass top warming
zone section.
• See the Electric warming drawer section.
Excessive condensation
Liquid in warming drawer.
• Remove liquid.
in the warming drawer
Uncovered foods.
• Cover food with lid or aluminum foil.
Temperature setting too high.
• Reduce temperature setting.
Food dries out in the
Moisture escaping.
• Cover food with lid or aluminum foil.
warming drawer