GIGABYTE GA-7VA1004 - Manual (Page 10)

- 4 - GA-7VA Motherboard
English
þ The GA-7VA motherboard þ 2 Port USB Cable x 1
þ IDE cable x 2/ Floppy cable x 1 o 4 Port USB Cable x 1
þ Motherboard Settings Label o Audio combo Kit x1
þ GA-7VA user's manual o IEEE 1394 Cable x1
o RAID Manual o SPDIF KIT x1 (SPD Kit)
þ CD for motherboard driver & utility (Driver CD) o I/O Shield
þ Quick PC Installation Guide
Item Checklist
Computer motherboards and expansion cards contain very delicate Integrated Circuit (IC) chips. To
protect them against damage from static electricity, you should follow some precautions whenever you
work on your computer.
1. Unplug your computer when working on the inside.
2. Use a grounded wrist strap before handling computer components. If you do not have
one, touch both of your hands to a safely grounded object or to a metal object, such as
the power supply case.
3. Hold components by the edges and try not touch the IC chips, leads or connectors, or
other components.
4. Place components on a grounded antistatic pad or on the bag that came with the
components whenever the components are separated from the system.
5. Ensure that the ATX power supply is switched off before you plug in or remove the ATX
power connector on the motherboard.
If the motherboard has mounting holes, but they don’t line up with the holes on the base and there are
no slots to attach the spacers, do not become alarmed you can still attach the spacers to the mounting
holes. Just cut the bottom portion of the spacers (the spacer may be a little hard to cut off, so be careful
of your hands). In this way you can still attach the motherboard to the base without worrying about short
circuits. Sometimes you may need to use the plastic springs to isolate the screw from the motherboard
PCB surface, because the circuit wire may be near by the hole. Be careful, don’t let the screw contact
any printed circuit write or parts on the PCB that are near the fixing hole, otherwise it may damage the
board or cause board malfunctioning.
Installing the motherboard to the chassis…
WARNING!