Grizzly G4227 - Manual (Page 11)

-10- G4227 Sliding Table
Figure 4. Mounting lower guide rail bracket.
5. Install the lower guide rail bracket to the
stand/cabinet, using the two
5 ⁄
16
''-18 x 3 ⁄
4
'' hex
bolts, hex nuts and flat washers supplied.
Figure 4 .
Figure 5. Mounting the lower rail.
6. Thread the mounting studs into the lower rail
approx.
1 ⁄
2
''. Attach the lower rail to its mount-
ing bracket. Figure 5.
7. Adjust the lower rail so its centerline is
approximately even with the edge of the
upper guide rail bracket.
Figure 6.
Figure 6. Lower rail alignment.
Figure 7. Mounting the bracket.
8. With the sliding table upside down, mount
the guide bearing bracket arm using the four
1 ⁄
4
''-20 x 3 ⁄
4
'' cap screws, flat washers and
lock washers provided. Figure 7. Lift up on
the bracket arm while tightening to ensure
the cap screws will be at the end of the slot.
If this detail is overlooked, the head of the
cap screws will not allow the fence to swing
to 45˚.