Grizzly H0583 - Manual

Specifications
Drive Size .......................................................... 1"
Bolt Size Capacity .......................................... 1
3 ⁄
4
"
No-Load Speed .................................. 3,000 RPM
Maximum Torque ................................. 1,400 ft/lb
Air Inlet Size .............................................
1 ⁄
2
" NPT
Air Consumption ...................................... 14 CFM
Operating Pressure ................................... 90 PSI
Maximum Operating Pressure ................. 115 PSI
Weight ......................................................28.6 lbs
Inventory
A.. Impact Wrench ........................................... 1
B.. Side Handle ................................................ 1
C.. Cap Screws ................................................ 4
Setup
Secure the side handle to the impact wrench with
the cap screws.
MODEL H0583
1" HEAVY–DUTY
TWO–HAMMER
IMPACT WRENCH
INSTRUCTION SHEET
Figure 1.. Model H0583
COPyRIgHT © MAy, 2008 By gRIzzLy INDuSTRIAL, INC.
WARNINg: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF gRIzzLY INDUSTRIAL, INC..
#JM10694 PRINTeD IN TAIWAN
INJURY HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EYE/EAR INJURY HAzARD!
Wear safety glasses and
hearing protection when
using this tool!
DO NOT EXCEED 115 PSI!
Personal injury could
occur..
SHATTERINg HAzARD!
Use sockets rated for
impact wrench use only..
Operation
Install any 1" drive socket into your air impact
wrench. Flip the forward/reverse switch, shown in
Figure 1, to change direction. Connect to air line
regulated at 90 PSI. using both hands, securely
hold onto the impact wrench and squeeze the
throttle.
Maintanence
The impact wrench MuST be regularly lubricated
with 3-4 drops of air tool oil directly into the air fit-
ting before each use. For best results, we recom-
mend using an in line filter, lubricator, and regula-
tor, as shown in
Figure 2..
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2 .. Installing your tool.
Side Handle
Forward/Reverse
Switch
Throttle