Grindmaster TEA-300 - Manual (Page 9)

To Remove the Water Tank Heating Element
1. Disconnect the power cord and remove the top cover.
2. Disconnect the wire leads to the heater and thermodisc.
3. Remove the spray head and the spray head nut.
4. Remove the tank cover after removing the (8) nuts securing
the cover to the tank. Lift the tank cover with the heating
element attached.
5. Remove the thermostat bulb bracket retaining the thermostat
bulb to the heating element.
6. Remove the heating element from the tank cover.
7. Replace the heating element with the sealing washers in the
same configuration; hold the element so that it does not twist
when tightening the element nuts.
8. Reinstall the tank cover in reverse order beginning with
item number 5.
American Metal Ware
®
Tea Brewers Page 8
Figure E