Grizzly G0565 - Manual (Page 15)

G0565 Adjustable Sponge Sander
-13-
Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving
machinery.
Operation Safety
SECTION 4: OPERATIONS
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
Sanding Belts
There are many types of sanding belts to choose
from. We recommend Aluminum Oxide for gen-
eral workshop environments. Below is a chart
that groups abrasives into different classes, and
shows which grits fall into each-class.
The general rule of thumb is to sand a workpiece
with progressively higher grit numbers, with no
one grit increase of more than 100.
Grit Type
24-36 Very Course
40-60 Course
80-100 Medium
120-180 Fine
220-360 Very Fine
Figure 6. Sanding belt controls.
To replace the sanding belts:
1. Unplug the sander from the power
source!
2. Loosen the lock lever shown in Figure 6 and
rotate the handwheel to remove the tension
on the belt.
Lock Lever
Handwheel
Tighten Loosen