Grizzly G9966 - Manual (Page 21)

24" & 27" Resaw Bandsaws -19-
Figure 16. Squaring table to blade.
Table Tilt
To tilt the table:
1. Disconnect power to the bandsaw!
2. Loosen the large hex bolt in the center of the
table trunnion.
3. Tilt the table to the desired angle. Refer to
the angle gauge.
4. Tighten the large hex bolt in the center of the
table trunnion.
2. Loosen the large hex bolt and the jamnut in
the center of the table trunnion.
3. Raise the upper blade guide assembly and
place a 6" machinist’s square on the table
against the blade as shown in
Figure 16.
Notice how far out of square your table is
and approximate this distance by adjusting
the positive stop up or down. Turning the
positive stop counterclockwise will raise it
and clockwise will lower it. Adjust the posi-
tive stop so the table will stop at a 90° angle
(square) to the blade.
4. Lock the positive stop by tightening the jam-
nut. Do not let the stop turn while tightening
the jamnut. Tighten the large hex nut in the
center of the table trunnion.
5. Set the angle pointer to zero on the table tilt
gauge.