Gardena Robitc Lawn Mower R40Li - Manual (Page 9)

English - 9
1. INTRODUCTION AND SAFETY
Transport
The original packaging should be used when
transporting R40Li over long distances.
To safely move from or within the working area:
1. Press the STOP button to stop the mower. If
security is set to the medium or high level (see
6.5 Security ), the PIN code has to be entered.
The PIN code contains four digits and is selected
when you start the mower for the first time. See
3.8 First start-up and calibration.
2. Set the main switch to 0 .
3. Carry the mower by the handle at the rear under
the mower. Carry the mower with the blade disc
away from the body.
Maintenance
• Inspect R40Li each week and replace any
damaged or worn parts.
Check especially that the blades and blade disc
are not damaged. Replace all blades and screws
at the same time if necessary so that the rotating
parts are balanced, see
8.6 Replacing the blades .
IMPORTANT INFORMATION
Do not lift the mower when it is parked in the
charging station. This may damage the
charging station and/or the mower. Open the
cover and instead first pull the mower out of
the charging station before lifting it.
WARNING
When the mower is turned upside
down the main switch must always
be set to the
0 position.
The main switch should be set to the
0 position during all work on the
mower’s underframe, such as
cleaning or replacing the blades.