Grindmaster CC-302-20 - Manual (Page 16)

Removal of Inlet Valve
1. Disconnect power.
2. Drain tank. (see page 12)
3. Remove rear access panel.
4. Disconnect black hose from fan.
5. Remove two screws and lock nuts. (Figure GG)
6. Remove valve. (Figure HH)
7. Disconnect wire connection, hose clamp and hose. (Figure II)
8. Replace valve as needed.
Figure GG Figure HH Figure II
Figure CC Figure DD Figure EE Figure FF
Page 16 Crathco® Powdered Beverage Dispensers
Removal of Water Tank on Machines with Serial # 339305UK and Higher:
1. Disconnect power.
2. Drain tank. (see page 12)
3. Remove machine lid, rear access panel and dump valve access
panel. (Figure BB)
4. Disconnect wires from tank lid components and dump valves. (Figure CC)
5. Disconnect hoses from dump valves.
6. Remove mounting screws from rear of tank. (Figure DD)
7. Disconnect drain hose from bottom of tank. (Figure EE)
8. Lift out tank and replace as needed. (Figure FF)
Figure BB