Grizzly H5527 - Manual (Page 11)

H5527 18 Gauge Brad Nailer -9 -
OPERATIONS
Loading
When replacing nails in your Model
H5527, follow these guidelines:
Gauge: 18
Length:
5 ⁄
8
" – 2"
Capacity: 100
To load your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Grip the nailer firmly, and depress the
magazine latch, as shown in Figure 3.
Figure 4. Loading nails into magazine.
Figure 3. Releasing magazine latch.
3. Pull the magazine cover back until it
stops.
4. Point the nailer down and insert a stick
of brad nails into the magazine, as
shown in
Figure 4. Make sure that the
pointed ends of the nails rest in the slot
at the bottom of the magazine.
5. Push the magazine cover forward until
the magazine latch locks in place.