Grizzly 5 GALLON AUTOMATIC MIXING PAINT TANK H8226 - Manual (Page 8)

Model H8226 5 Gallon Automatic Mixing Paint Tank -6 -
Tank Assembly
To assemble the paint tank:
1. Attach the casters to the bottom of the
paint tank.
2. Connect a 1 /
4
NPT air supply hose (not
included), to the inlet fitting on the regu-
lator (
Figure 2).
3. Connect the machined compression
hose fitting and the 3 /
8
" NPT compres-
sion nut to the fluid outlet adaptor.
4. Connect the material hose (not includ-
ed), to the fluid outlet adapter.
5. Connect the barbed compression hose
fitting and the 1 /
4
" NPT compression
nut to the outlet fitting.
6. Attach the atomization air hose (not
included), to the air outlet fitting on the
regulator.
Regulator Assembly
Fluid Outlet Adapter
Inlet Fitting
Outlet Fitting
Lift Handle
Figure 2. Lid assembly identification.
Pump Assembly
Figure 3. Paint tank connect to air compressor and spray gun.
Install a pressure regulator (not included),
between the tank regulator assembly
(
Figure 3) and the spray gun.
Figure 3 depicts the paint tank connected
to a compressed air system with a filter/
regulator unit and a spray gun.
The filter/regulator unit will protect your
tool from damaging water build-up, and
allow you to adjust and maintain regulated
air pressure. If you plan on installing a
filter/regulator unit in your compressed
air system, always follow the connection
instructions that come with the unit.
Safety Valve
Pressure Gauge