Grizzly H7664 - Manual (Page 12)

H7664 2-in-1 Combination Nailer/Stapler -12 -
SECTION 4: OPERATIONS
Loading
Figure 3. Catch lever engaged and
magazine pusher retracted.
When replacing brads or staples in your
Model H7664, follow these guidelines:
Gauge: 18
Brad Length:
5 ⁄
8
"-2"
Staple Length: 5 ⁄
8
"-1 5 ⁄
8
" (crown 1 ⁄
4
")
Capacity: 100
To load your nailer/stapler:
1. DISCONNECT NAILER/STAPLER
FROM THE AIR SUPPLY!
2. Grip the nailer/stapler firmly, unlatch
the catch lever ( Figure 3), and pull the
magazine pusher back completely.
Figure 4. Loading nails into magazine.
3. Insert a strip of brads or staples, point-
ed-end down, into the magazine as
shown in
Figure 4.
Operating
If you have not read the safety instruc-
tions in this manual, do not operate the
nailer/stapler.
Before you operate your nailer/stapler,
place two to three drops of the included
oil into the quick connect fitting where the
nailer/stapler connects to the air supply.
To operate your nailer/stapler:
1. Connect the air supply to the quick
connect fitting.
4. Slide the staples or brads all the way
down to the nose of the nailer/stapler.
5. Push the magazine toward the nose of
the nailer/stapler until the catch lever
locks.
6. Reload the nailer when the magazine
sight window ( Figure 4) shows the nail
or staple level is low. The sight window
shows up to approximately 50 nails or
staples loaded.
Catch Lever
Pusher
Pusher
Sight Window
Magazine