GE Monogram Range - Manual (Page 13)

INSTALL ANTI-TIP DEVICE STEP 3
Installation
13
Anti-Tip Parts Provided
• Attach the Anti-Tip Brace onto the bottom
of the range in the recessed area. Install 2 hex
screws (provided) through the brace and into
the range.
NOTE: This Anti-Tip device may be installed on the
opposite side of the range.
Alternate Brace
Position
Hex Screws
Anti-Tip Brace
• Measure and mark Dimension A (see table below)
from the left (or right) side of the installation
location. If the countertop has an overhang,
add that dimension to Dimension A.
• Place the Anti-Tip Bracket against the floor
and back wall at the marked location. Mark screw
holes for fastening the bracket to the wall sole plate
and the floor.
• Drill 1/8" pilot holes at a 20° angle.
• Secure the bracket to the wall and/or floor with
at least 2 wood screws (provided).
For Concrete or Cement Construction: You must
use appropriate fastening hardware (not provided).
Anti-Tip Bracket
Anti-Tip Brace
4 Wood Screws
•
All ranges can tip.
• BURNS or other SERIOUS INJURIES
can result.
•
INSTALL and CHECK the ANTI-TIP
bracket following these instructions.
AHAM Anti-Tip
Safety Brochure
3 Hex Head Screws
(2 required, 1 extra)
To reduce the risk of tipping the range, the range
must be secured by a properly installed anti-tip bracket.
See installation instructions shipped with the bracket
for complete details before attempting to install.
To check if the bracket is installed and engaged properly,
carefully tip the range forward. The bracket should stop
the range within 4 inches. If it does not, the bracket must
be reinstalled.
If the range is pulled from the wall for any reason,
always repeat this procedure to verify the range
is properly secured by the anti-tip bracket.
If your range has no anti-tip bracket, call 1.800.626.8774
to receive one at no cost.
If the Anti-Tip device supplied with the range does not fit this
application, use the universal Anti-Tip device WB2X7909.
Read the AHAM Anti-Tip Safety Brochure packed
with the bracket.
Anti-Tip Bracket
A
Wall Sole Plate
Range A
30” 5-1/16”
36” 5-1/16”
48” 8-1/4”