V-belt – Grizzly G1010 User Manual
Page 21

G1010 4" x 6" Metal-Cutting Bandsaw
-19-
Components and Hardware Needed:
Qty
V-Belt ..................................................................1
To install the V-belt:
1. UNPLUG THE BANDSAW!
2. Lift the motor and slip the V-belt over both
pulleys as shown in
Figure 14. Make sure
the belt is on parallel sheaves.
V-Belt
Figure 16. V-belt in place and tensioned.
3. Lower the motor, apply downward pres-
sure on the motor base and adjust the V-
belt tension knob to tension the belt (see
Figure 15). Apply enough tension so the belt
deflects about
1
⁄
2
" with moderate pressure
when pinched together at the points shown
in
Figure 16.
4. Close the pulley cover.
Figure 15. V-belt tension knob.
V-Belt Tension Knob
Figure 14. Installing V-belt.
See also other documents in the category Grizzly Power saws:
- G0506 (56 pages)
- 12" Cold Cut Saw G0682 (52 pages)
- G1127 (3 pages)
- 24" & 27" Resaw Bandsaws G3619 (56 pages)
- H7197 (1 page)
- INDUSTRIAL BANDSAW W/FOOT BRAKE G0513X2F (108 pages)
- Heavy-Duty Table G1023Z (63 pages)
- G0641 (56 pages)
- Air Cut-Off G8122 (2 pages)
- Ultimate 14" Bandsaw G0555 (68 pages)
- G4186Z (48 pages)
- H8145 (36 pages)
- G0691 (11 pages)
- G0691 (92 pages)
- G0592 (60 pages)
- Model G1022proz (84 pages)
- G0605X1-6X1 (12 pages)
- Model G1023zx3 (63 pages)
- G1016 (30 pages)
- H0604 (10 pages)
- ZX (63 pages)
- g0531b (8 pages)
- G3620 (56 pages)
- G1023SL (50 pages)
- G1023SLWX (3 pages)
- 50/65 Ton Ironworker G0647 (76 pages)
- Zero Clearance Table Insert H7396 (1 page)
- H7583 (28 pages)
- G0621 (60 pages)
- G0457 (64 pages)
- G0605X1 (101 pages)
- H0629 (3 pages)
- Slow Speed Cold Cut G0665 (40 pages)
- G0717 (60 pages)
- G0659 (60 pages)
- G0606X1 (12 pages)
- G0605X/G0606X (76 pages)
- G5787 (37 pages)
- G8599 (13 pages)
- T10131 (4 pages)
- G0513P (108 pages)
- G9906 (14 pages)
- G0513X2 (108 pages)
- G7211 (34 pages)
- G1052 (34 pages)