English, 10 set supervisor/user password – GIGABYTE GA-8I845GVM775 User Manual

Page 41

BIOS Setup

- 41 -

English

2-10 Set Supervisor/User Password

When you select this function, the following message will appear at the center of the screen to assist
you in creating a password.
Type the password, up to eight characters, and press . You will be asked to confirm the password.
Type the password again and press . You may also press to abort the selection and not enter
a password.
To disable password, just press when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is disabled,
the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all BIOS Setup
program function. When enabled, the Supervisor password is required for entering the BIOS Setup program
and having full configuration fields, the User password is required to access only basic items.
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be prompted for the
password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted only when
you try to enter Setup.

Standard CMOS Features

Advanced BIOS Features

Integrated Peri pherals

Power Management Setup

PnP/PCI Configurations

PC Health Status

Frequency/Voltage Control

ESC: Quit

KLJI : Select Item

F8: Q-Flash

F10: Save & Exit Setup

Change/Set/Disa ble Password

Load Fail-Safe Defaults

Load Optimized Defaults

Set Supervisor Password

Set User Password

Save & Exit Setup

Exit Without Saving

Enter Password: