GE 26998 - Manual (Page 29)

29
C
ALLER
ID
Problem Solution
No Display • Is battery fully charged? Try replacing the battery.
• Make sure that the unit is connected to a non-switched
electrical outlet. Disconnect the unit from the plug and
plug it in again.
• Did you order Caller ID service from your local telephone
company? The display won't work unless you order Caller
ID service from your phone company.
Caller ID Error Message • The unit displays this message if it detects anything other
than valid Caller ID information during the silent period
after the first ring. This message indicates either the
presence of noises on the line, or that an invalid message
has been sent from the telephone company.
A
NSWERING
S
YSTEM
S
OLUTIONS
Problem Solution
Can’t hear messages,• Adjust speaker volume.
beep, etc.
Time/Day setting • Set the time clock.
stuck at 12 a.m Mon.
Answers on 10th ring • Make sure answering system is turned on.
• Memory may be full.
Incoming messages • Was an extension phone picked up?
are incomplete • Memory is full.
• Accidentally pressed play/stop button during playback and
stopped message.
Won’t respond to • Must use tone-dial phone.
remote commands • Must enter correct security code.
• Did unit hang up? If you take no action for a period of time,
it automatically hangs up.