Grizzly Tow Draw Bar G8731 - Manual (Page 2)

-2-
g8731/g8732/g8733 tow draw Bar
Installation
1. Make sure the 2" x 2" square hitch receiver
and the tow draw bar are free from debris that
could interfere with proper installation, and
make sure that all devices used in towing are
in good working condition.
2. insert the shaft of the draw bar into the hitch
receiver, install the 5 ⁄
8
" hitch pin (not included)
through the hitch pin hole of both the receiver
and draw bar, then secure it in place with the
safety clip (see
figure 2).
figure 2. tow draw bar installed in "upper"
configuration.
hitch pin &
safety Clip
tow draw Bar
Ball hitch
assembly
hitch
receiver
Note: The tow draw bar can be installed into
the hitch receiver in the "upper" configuration,
as shown in
Figure 2, or with the tongue in
the "lower" configuration, depending on the
height of the trailer hitch.
Maintenance & Storage
Keep the tow draw bar free of debris and rust.
store it in a dry, protected place.
If you need help with your new tow draw bar, call
our Tech Support at: (570) 546-9663.