Garrett Metal Detectors Master Hunter CX Plus - Manual (Page 12)

www.garrett.com Master Hunter ® CX Plus Owner’s Manual
Replacement
1. Slide cover to the rear and slip off completely.
2. Take out battery pack which is not connected by
wire. It may help to turn the detector upside down.
Place your hand over the cavity to catch the pack as
it slides out.
3. Unscrew two thumbscrews to release the top and
remove batteries.
4. Install batteries. Carefully observe polarity of the
batteries.
5. Replace top on pack by tightening the two screws
and insert pack into the detector. Use finger pres-
sure only and do not screw too tightly.
6. Press down on the pack and begin sliding the bat-
tery cover until it snaps. Remove hand and continue
sliding cover until it snaps. Please note that your
Master Hunter CX Plus will lose its Audio Threshold
and Sensitivity settings when the battery pack is re-
moved for approximately four minutes.