Garrett Metal Detectors Graphic Target Profiling 1350 - Manual (Page 25)

Graphic Target Profiling 1350
™
OPERATING INSTRUCTIONS
1. Lower the searchcoil to a level approximately one
(1) inch above the ground.
2. Press the POWER touchpad, two (2) beeps
will sound to indicate the GTP 1350 is ON. Each
time the 1350 is turned on, it returns to the most
recent settings it was programmed to use, with
the exception of modifications made to the Notch
Discrimination settings in the pre-programmed
Modes. (See ACCEPT / REJECT on page 19 for
additional information.)
The GTP 1350 is engineered with Automatic Ground
Balance technology to continuously measure ground
mineralization and automatically adjust itself for
optimum performance.
3. Begin scanning by moving the searchcoil from
side to side in front of you, in either a straight line
or a slight arc pattern. Keep the coil level and at a
constant height of about one (1) to two (2) inches