Garmin STYLUS NX300 - Manual (Page 45)

Notices 45
Notices
Important Safety Instructions
Before using your all-in-one, read and follow these safety instructions:
■ Be sure to follow all warnings and instructions marked on the product.
■ Use only the type of power source indicated on the product label.
■ Use only the power cord that comes with the product. Use of another cord may cause
fires or shock. Do not use the cord with any other equipment.
■ Place the product near a wall outlet where the plug can be easily unplugged.
■ If you won’t be using the product for a long period, unplug the power cord from the
electrical outlet.
■ Always turn off the product using the P On button, and wait until the P On light
stops flashing before unplugging the printer or cutting off power to the electrical
outlet.
■ Avoid plugging the product into an outlet on the same circuit as a photocopier or air
conditioning system that regularly switches on and off, or on an outlet controlled by a
wall switch or timer.
■ Do not let the power cord become damaged or frayed.
■ If you use an extension cord with the product, make sure the total ampere rating of
the devices plugged into the extension cord does not exceed the cord’s ampere rating.
Also, make sure the total ampere rating of all devices plugged into the wall outlet does
not exceed the wall outlet’s ampere rating.
■ Place the product on a flat, stable surface that extends beyond its base in all directions.
It will not operate properly if it is tilted or at an angle.
■ When storing or transporting the product, do not tilt it, stand it on its side, or turn it
upside down; otherwise ink may leak from the cartridges.
■ Avoid placing the product in locations that are subject to rapid changes in heat or
humidity, shocks or vibrations, or dust.
■ Leave enough room around the product for sufficient ventilation. Make sure the
product is at least 4 inches (10 cm) away from the wall.
■ Do not place the product near a radiator or heating vent or in direct sunlight.
■ Do not block or cover openings in the product case or insert objects through the slots.