Grizzly Heavy-Duty Jointer G1182HW - Manual (Page 18)

-16- G1182 6" Series Jointers
1. Insert the steel rod through the hole in each
adjuster arm until the notches for the E-clips
extend past the adjustment arms on both
sides.
2. Attach the E-clips to the notches to lock
adjustment arms onto the steel rod. The
adjustment arms are symmetrical, so the
placement is not a concern. See Figure 13.
Figure 13. Knife setting gauge.
Knife Setting Gauge Pedestal Switch
G1182ZX Only
Your jointer comes with a pedestal mounted mag-
netic switch for safety and convenience. Simply
bolt the pedestal to the two mounting holes on the
back side of the stand with the supplied washers
and bolts. See Figure 13A.
Figure 13A. Mounting pedestal switch to stand.