Grizzly G0700 - Manual (Page 25)

Model g0700 (Mfg. since 8/09)
-23-
13. thread (2) M5-.8 x 12 cap screws with 5mm
lock washers through the switch bracket and
into the sliding table base (see
figure 19),
then tighten the cap screws.
12. attach the push handle assembly, as shown
in figure 18, with the two button head screws
and flat washers already installed in the
mounting holes.
figure 18. sliding table handle attached to end
of sliding table.
Button head
Cap screws
figure 19. Magnetic switch installed.
Magnetic
switch
15. tilt the blade assembly to 0˚, then move
the sliding table out of the way so you can
access the lower blade guard cover and
blade arbors.
16. insert the arbor lock tool into the hole shown
in figure 21, rotate the arbor until the arbor
lock tool seats, then install the main blade per
the instructions on
page 35 as a guide.
14. open the cabinet door and remove the motor
shipping brace shown in figure 20, then
replace the fasteners where they were. (save
the brace for future transport needs.)
figure 20. Motor shipping brace.
11. remove the shipping brace from the sliding
table, then install the sliding table end cover
over the fixed part of the sliding table end, as
shown in
figure 17, using the premounted
hardware. (save the brace for future trans-
port needs.)
figure 17. sliding table shipping brace and end
cover installed.
remove
shipping Brace
install end
Cover
figure 21. installing main blade.
arbor
Lock
tool