Grizzly G0700 - Manual (Page 24)

-22-
Model g0700 (Mfg. since 8/09)
6. the fence rail is pre-assembled with four rail
studs and accompanying hardware. remove
one hex nut, flat washer, and lock washer
from the end of each stud, as shown in
figure 13.
figure 13. hardware removed from fence rail
studs to prepare for installation.
7. install the rail with the studs through the holes
in the tables, as shown in figure 14, and use
the hardware removed in the previous step to
secure the rail to the tables.
do not tighten the hex nuts at this time,
because the rail still needs to be adjusted.
figure 14. round rail installed.
9. slide the rip fence base onto the round rail.
thread the handles and knob into the rip
fence base, where shown in
figure 15.
10. slide the rip fence onto the rip fence base
by sliding the fence t-slot over the clamping
plate (see
figures 15-16). Lock the fence by
tightening the fence lock handle.
figure 16. installing the rip fence.
Fence Lock
handle
t-slot for
Clamping plate
Knob
M10-1.5 x 70
figure 15. rip fence handles.
handles
M10-1.5 x 12
Clamping
plate
8. remove the large round washer attached to
the end of the fence rail. With this washer out
of the way, you will be able to slide the rip
fence base onto the rail.
Large round
Washer
stud