Garmin WORKFORCE 320 - Manual (Page 33)

Installing for the First Time 33
7. Wait while EpsonNet Setup configures your product for the network.
8. Follow the instructions on the screen to remove the USB cable from the
product and your computer.
9. When you see the Installation Complete screen, print a test page, then click
Finish .
10. Follow the on-screen instructions to install the rest of your software.
When installation is complete, remove the CD and restart your computer.
To set up additional computers to print to the product, see “Setting Up Additional
Computers” on page 37.
Setting Up With the Product Buttons
If you are using Mac OS X 10.6, or you did not connect a USB cable to set up the
product on your wireless network, follow these steps to set it up using the product
buttons:
1. Follow the instructions on the screen to start the product’s wireless Setup
Wizard.