beautypg.com

Existing structure, Factory avionics location – Garmin PAV80 User Manual

Page 10

background image

PS Engineering

PAV80 Series IFE System

Installation and Operator’s Manual

200-800-0101

Page 2-2

Rev 2 Sept. 2003

2.00”

6.31”

2.3.3 Mounting Rack Installation

Remove the unit from the mounting tray by unscrewing the 3/32" hex-head screw that is near the left edge
of the unit. Carefully slide the unit free of the tray. Set the unit aside in a safe location until needed. Install
the tray using six FHP 6-32 x ½" screws. The unit must be supported at front and rear of the mounting tray.
See Appendix B.

The tray mounting can be made in any area that exists for adding additional avionics. Instrument panel
mounting is accomplished in accordance with AC 43.13-2A, Chapter 2.

Existing Structure

(from behind

panel)

Avionics Mounting Rails

Existing Transponder

Center Avionics Stack

Factory Avionics Location

Factory Avionics Mounting Rails

Figure 2-2 Avionics Mounting Rails (Typical)

Figure 2-1 Typical Tray Installation Location