GE 29484GE2 - Manual (Page 18)

1
Memory
Each of the 8 memory buttons has the capability of storing 2 separate telephone
numbers (up to 32 digits each). Each memory button accesses an upper and a lower
memory location. The LOWER button accesses those numbers stored in the lower
memory locations. You can program the memory when the unit is idle or when you
are using the phone.
Storing a Number
1. Press the STORE button. The red indicator blinks indicating the unit is in Store Mode.
2. Enter the phone number you want to store using the keypad digits.
3. Press STORE again.
4. Press the memory location button (1-8) where you want to store the number. If you
want to store it in upper memory, simply press the memory location button. If you
want to store it in lower memory, press the LOWER button. The red indicator stays
on. Press the memory location button where you want to store the number.
5. For future reference, you may want to write the name or number of the party you
have stored in this location in the corresponding space on the memory index card.
6. Repeat steps 1-5 for any additional numbers you want to store, up to a total of 16.
7. To cancel the storing procedure at any time, press STORE twice or place the
handset on the cradle.
NOTE: The storage procedure will automatically cancel after 15 seconds
if no keys are pressed. Also, when pulse mode is used, pressing the
TONE* key before programming will store all digits in tone.
Changing a Stored Number
If you want to change the stored number, simply enter the new number over the old
number using the previous memory storing procedure. To erase a stored number,
press STORE twice, then the memory location you want to erase.