Grizzly G9922 - Manual (Page 28)

-28-
g9922 (mfg. since 12/01)
figure 39. Ball oiler (dust cover removed for
clarity).
ball Oiler (figure 39)
lubricate the ball oilers after every 2 hours of use.
use a manual oiler (oil can) filled with iso 68 or
sae 30W non-detergent oil. make sure to clean
the outside of the ball oiler before and after each
use to keep out contaminants.
To lubricate the ball oiler:
1. disconnect sander From PoWer!
2. look towards the spindle shaft behind the
rubber dust cover ( figure 39).
—if you can see the ball oiler, skip ahead to
Step 4.
—if you cannot see the ball oiler, proceed to
Step 3.
3. rotate the sanding drum by hand until it
moves up enough to expose the ball oiler.
4. insert the tip of the oil can into the ball oiler.
depress the ball with the tip of the oil can
nozzle and squirt a little oil inside the fitting.
Ball oiler