Grizzly G9922 - Manual (Page 27)

g9922 (mfg. since 12/01)
-27-
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
failure to do this may
result in serious person-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
• Loose mounting bolts.
• damaged sanding sleeve.
• Worn or damaged wires.
• loose sanding spindle or sleeve.
• any other unsafe condition.
• Clean the machine.
Monthly Check:
• Lubricate the table tilt assembly.
Schedule
Cleaning the Model g9922 is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. if any
resin has built up, use a resin dissolving cleaner
to remove it. treat all unpainted cast iron and steel
with a non-staining lubricant after cleaning.
Cleaning
protect the unpainted cast iron surfaces on the
table by wiping the table clean after every use—
this ensures moisture from wood dust does not
remain on bare metal surfaces.
Keep tables rust-free with regular applications of
products like g96 ® gun treatment, slipit ® , or
Boeshield ® t-9.
unpainted Cast Iron
the bearings in the motor are shielded, perma-
nently lubricated and require no maintenance.
Every month, the table tilt assembly should be
greased to prevent corrosion and keep the table
moving freely.
Table Tilt Assembly
1. disconnect sander From PoWer!
2. apply a light layer of multipurpose grease to
the areas indicated in figure 38 and to the
corresponding areas on the other side of the
table tilt assembly. tilt the table several times
to disperse the grease.
Lubrication
figure 38. table tilt grease points.