GE PROFILE PDE9900 - Manual (Page 20)

– 20 –
Middle Spray Arm
1. Check holes in spray arm for bits of china, seeds,
and other foreign matter.
2. Check spray arms for rotation.
Removal and Replacement
1. Pull upper rack all the way out.
2. Remove plastic screw on bottom of middle
spray arm. This will allow the middle spray arm
and bearing to be removed.
Note: Install middle spray arm with spray jets facing
the upper rack. Place bearing between spray arm
screw and bottom of the middle arm.
Note: If the upper rack experiences poor cleaning
problems, ensure the middle spray arm is turning
freely. If not, disassemble the middle spray arm and
clean the bearing surface, then reassemble.
Using the Dishwasher with the Upper Rack
Removed
1. Unsnap and remove the end cap on each side of
the rails.
2. Pull the rack straight out and off the rails.
3. Replace the end caps.
4. Push the rails all the way back into the
dishwasher.
5. Slide the shower nozzle attachment over the
spout.
6. The dishwasher is now ready for use.
Note: Always use the shower nozzle when the upper
rack is removed.