GE 2-920SST User Manual
Page 6
6
1. Plug the power supply cord into the 9V DC jack on the base and into an
AC outlet.
2. Place handset in the base to charge for 12 hours. The CHARGE/IN USE
light comes to indicate that the battery is charging.
If you don’t charge the handset battery properly (for 12 hours) when you first
set up the phone, the battery’s long-term performance will be compromised.
3. Set the TONE/PULSE switch to TONE for touch-tone service, or PULSE
for rotary service. If you don’t know which type of service you have,
check with the phone company.
4. Select RINGER ON or OFF (on the side of handset). When you select
OFF, the handset doesn’t ring.
5. Raise the base antenna.
6. Plug the telephone line cord into the PHONE LINE jack on the back of
the base and into a modular jack.
7. Set RING SELECT switch to 3 rings, 5 rings or TS (Toll Saver) according
to your requirement.
NOTE:
Use only the Thomson AC power adapter that came with this unit
(5-4083). Using other adapters may damage the unit.
D
ESKTOP
I
NSTALLATION
TONE/PULSE switch
1
2
6
4
3
5
7
RING SELECT switch