GE 2-920SST - Manual (Page 27)

27
Problem Solution
Unit beeps • You may be receiving an out-of-range alert, move closer to
the base.
• Place handset in base for 10 seconds to reset the
phone. The CHARGE/IN USE comes on when reset is
successful.
• Put handset in base for 12 hours to recharge battery.
• Clean charging contacts on handset and base with a soft
cloth or an eraser.
• See solutions for “No dial tone.”
• Replace battery.
TALK light keeps flashing • The base unit and the handset aren’t connecting with each
other. Place the handset in the base for 10-15 seconds (the
CHARGE/IN USE light on the base blinks one time.
Cannot hear the • Set the RINGER to ON.
PAGE/FIND tone
Range is shorter • Position the base antenna upward.
than normal
Battery will not hold a • Be sure you are sufficiently charging the battery.
charge The battery should be charged for 12 hours.
• Make sure battery contacts on both the handset and the base
are making contact and are clean; free of dirt or lint.
• When the handset is placed in the base, make sure that the
base CHARGE/IN USE light is on.