Global Machinery Company REDEYE LSSLV - Manual (Page 7)

13 12
If the air bubble is outside of the black circle, follow these recommend
adjustment steps:
• It is important to check if the unit has been placed on a level surface.
The diagrams below illustrate the correct positioning of the unit.
• If the unit is relatively flat, you can use the adjustment dial (4) to make
adjustment only on the vertical plane.
• If the surface is not flat on a horizontal plain, you have a few options:
• Use a flat piece of material (books, block of timber)
• Use a tripod
Suggestion: A tripod with an adjustable plate may be the best tool to use,
to ensure the self leveling vertical line generator is in a level position.
Caution: Ensure the switch is in “0” position during adjustment.
Projecting Level Vertical Laser Line
When the self leveling
vertical line generator is
located in level position:
• Ensure the laser
aperture (5) of the
tool faces the wall
which will be used for
projecting the laser
“chalk line”.
• Switch on the self leveling vertical line generator, you will see the vertical
laser line swaying on the wall, whilst it automatically adjusts itself.
This process will take approximately 5 seconds where you will see
eventually a steady vertical laser “chalk line”.
• Once the vertical laser “chalk line” has steadied, position the “chalk
line” to your target position.