Grizzly H3390 - Manual (Page 22)

H3390 Wet Tile Saw -17-
Rip Fence
When multiple tiles need to be cut to the same
dimension, the rip fence can increase production.
Use the scale on the table to set the rip fence to
the desired cut. Make several test cuts to check
the accuracy.
If the scale on the table does not produce accu-
rate cuts, the scale and table position can be fine-
tuned by loosening the cap screws (See
Figure
21 ) and adjusting the table.
Figure 21. Table fine-tuning cap screw.
Figure 22. Bevel cutting a tile edge.
45˚ Fence
45˚ beveled edges are cut on tiles using the 45˚
miter fence. Use the cutting groove in the center
of the table to support the tile edge (
Figure 22 ) as
you slide the tile and table into the saw blade.
Cap Screw
(1 of 2)