Graco 8482 - Manual (Page 31)

31
A lap/shoulder combination belt with a
latchplate that can slide freely along the
belt

requires the locking clip, unless your
vehicle’s seat belt can be converted in another
way that is described in your vehicle owner’s
manual. See your vehicle owner’s manual to
find out if your vehicle belt can be converted to
prevent movement of the lap portion of the
belt. Otherwise, the locking clip MUST
be used.
10. To install the locking clip:
a. Tighten the buckled vehicle belt by pushing
down hard on the car seat and pulling hard on
the shoulder belt.
b. While continuing to push down on the car
seat, let go of the shoulder strap and pinch
the two straps together just behind the
buckle tongue.
c. While still pinching the straps together,
unbuckle the vehicle belt. Do not allow the
straps to slip.
d. Connect the lap
belt to the shoulder
belt by placing the
locking clip on the
belts about ½ inch
from the buckle
tongue as shown
Ž
.
½
inch

Ž