Grizzly G1067Z - Manual (Page 12)

-10- G1067Z Wood Lathe
Assembly of the G1067Z is straightforward. We
have organized the assembly process into steps.
Please follow them in sequence.
Tools Required: Only a few common tools are
needed to assemble this machine. Specifically, a
6" adjustable wrench, 12mm open end wrench,
regular and Phillips head screwdriver and an
8mm Hex wrench.
Figure 1.
1. Locate all four stand legs and the two end
panels. Attach an end panel to any two of the
legs using the 10-24 x
3 ⁄
8
'' Phillips head
screws provided ( Figure 1). Repeat this step
for the remaining end panel/legs. DO NOT
final tighten the bolts at this time.
Stand Pre-assembly
SECTION 2: ASSEMBLY
Wear safety glasses dur-
ing the entire set up
process!
This machine presents
serious injury hazards
to untrained users. Read
through this entire man-
ual to become familiar
with the controls and
operations before start-
ing the machine!
Figure 2.
2. Bolt the upper mount plate and the short
stand support to each end assembly using
the
5 ⁄
16
''-18 x 3 ⁄
4
'' carriage bolts provided
( Figure 2).